Safe operating procedures for glazing machines

 Safe operating procedures for glazing machines

1. Press the bell before starting the machine, and stick to their respective jobs after starting the machine.

2, careful operation, found that the paper skew brake, do not rush to grab paper, found that the chain off the rails in the oven brand material block, should cut off the power to deal with. 3, insert cards, do not wear gloves.

4, scrub rolling brand roller, should cut off the power supply, do not use hand grab paper.

5. When the rubber roller of paper roll is found, the power supply should be cut off and the paper is not allowed to be grabbed by hand.

6, found electrical fault or leakage phenomenon, should immediately shut down, cut off the main power supply, please electrician repair.

7. Do not remove the safety baffle at will.

8. Before leaving work, do a good job of environmental sanitation, positioning management and equipment tidiness on duty, and cut off the power switch.

Note:

1. When the machine is not running, it is forbidden to turn on the UV lamp.

2, lng time stop, the pressure of the cots to back off, in case of long-term compression deformation.

3. When the rubber roller and rubber rod cylinder are pressed, it is forbidden to run the machine without light oil, place dry friction, and damage the rubber roller.

4. When drawing samples, we should pay attention to gestures to prevent hand lifting too high and being injured by tooth row.

5. When rising the paper receiving table, we should concentrate highly to prevent the paper stool or the paper pile on the paper stool from hitting the paper machine, and then damaging other parts, such as the tooth row and so on. When ascending the paper feeding table, it is necessary to prevent the paper pile stool from exceeding the limit and hitting the Feida head.

6. When dropping the paper feeding table and collecting table, avoid crushing the foot.

Therefore, good glazing machine quality is the need for a good device to do a strong backing. Welcome new and old customers to visit the company to negotiate!